Advanced internet access point settings for data calls
After setting up a basic internet access point for
Data call
or
High speed (GSM)
, select
Options
>
Advanced settings
, and define
the following advanced settings:
•
IPv4 settings
— Enter the device IP and name server addresses for the IPv4 internet protocol.
•
IPv6 settings
— Enter the device IP and name server addresses for the IPv6 internet protocol.
•
Proxy server address
— Enter the proxy server address.
•
Proxy port number
— Enter the proxy server port number. Proxy servers are intermediate servers between a browsing service
and its users, which are used by some service providers. These servers may provide additional security and speed up access
to the service.
•
Use callback
— Select
Yes
if you have a service that dials back to your device when you establish an internet connection.
•
Callback type
— Select
Use server number
or
Use other number
, according to instructions from your service provider.
•
Callback number
— Enter your device data call phone number, which the callback server uses.
•
Use PPP compression
— Select
Yes
to speed up the data transfer, if it is supported by the remote PPP server.
•
Use login script
— Select
Yes
, if your internet service provider requires a login script, or if you want to automate your login.
A login script is a sequence of instructions that the system follows during the login process.
•
Login script
— Enter the login script. This setting is available only if you have selected
Use login script
>
Yes
.
•
Modem initialisat. string
— Enter a command string for the connection setup, if required by your service provider.